Filter
Top Products
Using Optional Equipment Page 28
Before transporting the scanner, turn it off, remove the TPU, and reinstall
the shipping screw in the outer shipping hole labeled CLAMP. The
transportation lock at the back of the scanner must also be in the LOCK
position before you move the scanner (see
Setting Up and Using Your
Scanner).
Installin
g
the Trans
p
arenc
y
Unit
Follow the steps below to install the TPU:
1
Make sure the scanner is turned off. Then unplug the power cable from
the scanner.
2
Remove the document cover by grasping the back of the document
cover as shown and easing the cover up.
If you can’t insert the
shipping screw in the
hole labeled CLAMP
when you prepare
the scanner for
transportation, the
TPU’s lamp
assembly may not be
in its home position.
If this is the case,
slowly raise the front
of the TPU to allow
the lamp assembly to
slide to the home
position.