Filter
Top Products
56 Presenting Through a Wireless Network
Starting EasyMP
Before connecting to the projector, you have to switch it to EasyMP
mode. Follow these steps:
1. Point the remote control at the projector and press the P
Power
button.
2. Press the
EasyMP button on the remote control to select EasyMP
as the source.
You see this screen. The network settings appear in the lower left.
3. If you’ve already set up your computer and projector for the mode
you want to use—Ad Hoc mode (also called computer-to-
computer mode) or Access Point mode (also called infrastructure
mode)—skip to “Projecting Over a Network” on page 81.
Otherwise, continue with the next section.
note
Use only the Epson
802.11a/b/g wireless module
in the projector.
If you see a message asking
you to insert a LAN or
memory card, check to make
sure your 802.11 a/b/g
module is properly inserted
(see page 52).