Filter
Top Products
Configuration and Management
Figure 27 Scan for wireless networks page
When the scanning is finished, the following information about identified
wireless networks is displayed:
The MAC address of the access point of
the wireless network.
MAC
Address
The name of the wireless network.
Network
Name
The radio channel used by the wireless
network.
Channel
The radio signal strength.
RSSI
Use this information to decide which channel to use for the Ericsson W20
wireless network. Click Back
to return to the Wireless LAN page where
you can select this channel.
To avoid interference with other wireless networks, the transmit power level
can be reduced. If you want to change the transmit power level according
to your specific conditions, select an appropriate level from the Transmit
Power [dbm] list.
Click Apply to save the settings.
2.6.2 Network Name
All devices on the local wireless network share a common Service Set
IDentifier (SSID) or network name. This name is required to establish
connection between the Ericsson W20 and other wireless device(s) and to
distinguish the wireless network from any other(s) that may be in use
nearby. It ensures that only devices configured with the same network
name as the one set on the Ericsson W20 can obtain access to it.
26 1/1551-CRH 102 167 PA15 2006-08-16