Filter
Top Products
Pressure Systems, Inc. 98RK-1 & 9816 User’s Manual©
Page 14 www.PressureSystems.com
STEP 13
To set the PC address: Select "Use the following TCP/IP address." It is suggested
that the IP Address read 200.xxx.yyy.zzz where xxx, yyy, and zzz are unique
locations that do not match any other address on the network. (Check with your
network administrator to see that the numbers chosen do not conflict with any other
addresses on the network.) It is suggested that the IP address should, as a default,
read 200.1.1.1. This should allow you to talk with any other modules on the
network. The Subnet mask should read 255.0.0.0. Select OK. The host computer is
now set to communicate via the Ethernet card to the 9816 module.