Filter
Top Products
Configuring Wireless Ports
Summit 300-48 Switch Software User Guide 79
Configuring Wireless Ports
The configure wireless ports commands allow you to configure properties such as the IP address
and the location of the port.
Table 23 lists the configuration commands for wireless ports.
Table 24 identifies property values for the wireless port configuration commands.
Configuring Wireless Port Interfaces
Each wireless port on the Summit 300-48 switch contains two interfaces. Interface 1 supports 802.11A,
and interface 2 supports 802.11G radio signals. The
configure wireless port interface commands
allow you to configure one of the two individual interfaces (1|2) on a port or ports. You can move an
interface from one profile to another without having to shut it down.
Table 23: Wireless Port Configuration Commands
Command Description
config wireless ports <portlist> <property> Configures the named property for the specified
port or ports. See Table 24 for <property> values.
reset wireless ports <portlist> Resets the specified ports.
enable | disable wireless ports <portlist> Administratively enables or disables a wireless port
for use.
enable | disable wireless ports <portlist> time
<date> <hour>
Enables | Disables the specified ports at the given
date (m/d/yyyy) and hour (0-23).
enable | disable wireless ports <portlist> every
<hour>
Enables | Disables the specified ports every date at
the specified hour.
enable | disable wireless ports <portlist>
cancel-scheduler
Cancels previously scheduled enable or disable
scheduling commands for the port.
Table 24: Wireless Port Configuration Property Values
Property Default Allowed Values Description
ipaddress 192.168.0.100 + port number (1-48) NA Indicates the source IP address. The
IP address must be an IP address on
the management VLAN.
location “Unknown Location” N/A Identifies the location to be
configured.
health-check on off | on Indicates whether the health check
reset function is on or off. This
determines whether the port should
be reset if the health check timer
expires.