Filter
Top Products
2-3DVS 100 and DVS 150 Installation
Installation
Overview
To install and set up the DVS 100 or DVS 150, follow these basic steps:
1
If desired, mount the scaler in a rack (see “Mounting the scaler”
below). Otherwise, install the rubber feet (see “Installing the
rubber feet” on page 2-4).
2
Turn off power to the input and output devices, and unplug the
power cables from them.
3
Attach the scaler to the input devices and the output devices. See
“Cabling” on page 2-5.
4
Plug the scaler, input devices, and output devices into a grounded
AC source.
5
Turn on the input and output devices.
6
Use the LCD menu screens to configure the scaler. See
“Configuring the Scaler” on page 2-7.
7
The image from the input device should appear on the output
device. If it does not, double check steps 3 and 4 and make
adjustments as needed, and then see “Operating Problems” on
page 5-2.
Mounting the scaler
Each DVS 100 and DVS 150 ships with four uninstalled rubber feet. If
you are going to rack mount the unit, do so before cabling it, and do not
install the rubber feet. If you are not rack mounting the scaler, skip to
“Installing the rubber feet” on page 2-4.
The DVS 100 or DVS 150 can be rack mounted using one side of an
optional 19” 1U Universal Rack Shelf (Extron part # 60-190-01).
To rack mount the scaler, do the following:
1. If rubber feet were previously installed on the bottom of the case,
remove them.
2. Mount the scaler on the rack shelf as shown in figure 3. Use two
4-40 x 1/8” screws in opposite (diagonal) corners to secure the case
to the shelf.