Filter
Top Products
SVS 100 Serial Communication
5-3
Symbol definitions:
= CR/LF • = space
= Video inputs, 1 - 4, 0 = none (black)
= Audio inputs, 1 - 4, 0 = none (mute)
= Audio gain, 0 thru 9 (dB)
= Audio attenuation, 1 thru 15 (dB)
= Numerical value, -15 thru +9
= User presets, #1 thru 128
= Audio switch mode (how audio is switched between inputs),
0: beginning of duration; 1: middle of duration; 2: end of duration;
3: fade (gradual)
= Picture contrast, 0 - 150
= Picture brightness, 0 - 50
= Picture tint, 0 - 32
= Picture color, 0 - 100
= 1 (on) or 0 (off)
Xe
= Effect type, (0 - 10) 0: cut; 1: dissolve; 2: soft wipe; 3: solid wipe;
4: soft curtains; 5: hard curtains; 6: square; 7: diamond; 8: circle;
9: X effect; 10: + effect
g
= Top and bottom blanking values, 0 thru 16
h
= Video type detected, (0 - 4) 0: no input; 1: NTSC 3.58; 2: PAL;
3: NTSC 4.43; 4: SECAM
i
= Video output type, 1: NTSC; 2: PAL
j
= Video input selection, 1: Auto; 2: Video (Composite); 3: S-video
Xk
= Duration period, (0 - 48), where 0 = 0.2 seconds and each increment of
the duration period adds 0.1 seconds to the duration time.
As examples, a duration period of 25 is equal to 0.2 + (25 x 0.1) = 2.7
seconds, and a duration period of 48 is equal to 0.2 + (48 x 0.1) = 5.0
seconds.
Xt
= Transition list A, (0 - 7) 0: left-to-right; 1: right-to-left; 2: top-to-bottom;
3: bottom-to-top; 4: top right-to-bottom left; 5: top left-to-bottom right;
6: bottom right-to-top left; 7: bottom left-to-top right
Transition list B, (0 - 7) 0: horizontal in; 1: horizontal out; 2: vertical in;
3: vertical out; 4: diagonal right in; 5: diagonal right out; 6: diagonal left
in; 7: diagonal left out
Transition list C, (0 - 1) 0: in; 1: out
Using the command/response table
The command/response table is shown on the following pages. Lower
case characters are acceptable in the command field only where indicated.
Symbols are used throughout the table to represent variables in the
command/response fields. Symbol definitions are shown below, and an
ASCII-to-hexadecimal (HEX) conversion table is shown in figure 5-1.
Command and response examples are shown throughout the command/
response table.
soft wipe, hard wipe A
soft curtains, hard curtains B
square, diamond, circle, X effect, + effect C
Effect type Transition list