Filter
Top Products
FS-RA-CLX_SlotServer_Instruction_Manual_(T17011) Page 7 of 34
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldServer.com
4. SlotServer Installation
The SlotServer plugs directly into the AB1756 ControlLogix rack. Take note of the slot number
used for the SlotServer as this will be needed when configuring the I/O in the RSLogix software.
4.1. SlotServer Ports and Displays
Note that there are several hardware ports available on the SlotServer card, but that this
SlotServer model only makes use of a select few. The ports and displays of interest are as
shown in the diagram below:
Scrolling Display
This will Display an OK status when the SlotServer has powered up successfully.
Card Status Indicators:
The Comm and OK lights will indicate green when the SlotServer has powered up
successfully. The Sys indicator will indicate green if the external nodes are all
communicating properly; and red otherwise.
Service Pin
To be used for commissioning the SlotServer into a LonWorks network
Scrolling display shows card messages
Card Status Indicators show general card
status
Service Pin for LonWorks Commissioning
Communications Status LED’s show status of
communications and card software.
TP/FT10 LonWorks Connection
Ethernet Port. Used for configuration and
Ethernet Protocols.
RS-485 Port. Specify as R1 in the
configuration.