Filter
Top Products
20
Chapter 2 Installation
✐ Password setting must be done when you connect the projector to the network. This setting
is carried out through the projector’s menu and also it can be set through the network using
the web browser. For further information please refer to item “Initial Setting/Password set-
ting” (☞ p.30).
✐ Valid characters for password are only 4 digits numeric numbers 0 to 9. The number “0000”
means no password set.
✐ This password is not to restrict the use of the projector. This password is to set the security
against the use of the projector through the network.
Password setting
A password can be set to restrict access to the setting pages of the projector using
the web browser. The default password is set “0000” as no password.
1 Use the projector’s menu and select the Network setting icon on the menu.
2 Select the Network setting sub icon from the submenu, and then press SELECT
button once. Check that the mode is “On”.
3 Select the Password sub icon and then press SELECT button once.
*The setting window appears. The numbers on the display indicates the current password.
4 Enter your desired number by using the point buttons on the projector or remote
control handset, and then select Set and press SELECT button.
*The password setting window disappears and the network unit begins restarting. It takes
about 40 seconds. Do not turn off the mains switch during this period.
*The password can be entered by using the screen 10-key pallet (☞ P.21).
How to enter the numbers with point buttons
To move the selection and change the value, use the point buttons (d e 7 8) on the
projector or on the remote control handset.
The point buttons 7 8 are used to select the column.
The point buttons d e are used to change the numbers up and down.
Network setting