Filter
Top Products
33
Network Unit
OWNER’S MANUAL
ENGLISH
E-mail Setting
This product has an E-mail function which can send an alert message to
users or an administrator if it detects an abnormality on the projector or run
out of the life span of the lamp. Click E-Mail Setting on the main menu and follow the
below steps.
1 SMTP Server*
1
Type the E-mail address of SMTP server and administrator and click Set button.
The administrator address is set to "Reply-To" address sent from the projector.
*1 The SMTP server is a server for sending E-Mail. Please contact your network administra-
tor to have this SMTP server address.
* If the network unit sends an alert message due to the abnormality on the projector but the
SMTP server is down in some other reason, the message does not be sent. In this case,
the message “Unable to connect to server.” will be displayed on the setting page. Click
Set button to remove the message.
✐ To use the E-Mail function, it must be set the DNS address on the Network setting page correctly.
✐ You cannot use this E-mail function if the DNS server and SMTP server cannot be used in
your network environment. If the SMTP server is located in your LAN (Local Area network),
the address set to SMTP server should be specified the in SMTP server located in your LAN.
The server located outside of your LAN may not be available for security reason. For further
information please contact your network administrator.
✐ Up to 10 E-mail addresses can be registered.
E-mail Setting