Filter
Top Products
Configuring Configuring Transparent mode
FortiGate-30B FortiOS 3.0 MR6 Install Guide
01-30006-0459-20080505 27
To add an outgoing traffic firewall policy
1 Go to Firewall > Policy.
2 Select Create New.
3 Set the following and select OK.
To add an incoming traffic firewall policy
1 Go to Firewall > Policy.
2 Select Create New.
3 Set the following and select OK.
Firewall policy configuration is the same in NAT/Route mode and Transparent
mode.
Note that these policies allow all traffic through. No protection profiles have been
applied. Ensure you create additional firewall policies to accommodate your
network requirements.
Using the CLI
After connecting to the CLI, you can use the following procedures to complete the
basic configuration of the FortiGate unit. Ensure you read the section “Connecting
to the CLI” on page 19 before beginning.
Switching to Transparent mode
The FortiGate unit comes preset to NAT mode. You need to switch to Transparent
mode.
To switch to Transparent mode
config system settings
set opmode transparent
set manageip <address_ip> <netmask>
set gateway <address_gateway>
end
Source Interface Select the port connected to the network.
Source Address All
Destination Interface Select the port connected to the Internet.
Destination Address All
Schedule always
Service Any
Action Accept
Source Interface Select the port connected to the Internet.
Source Address All
Destination Interface Select the port connected to the network.
Destination Address All
Schedule always
Service Any
Action Accept