FortiSwitch-5003A and 5003 Fabric and Base Backplane Communications Guide
30 01-30000-85717-20081205
Fabric gigabit switching to the network FortiGate-5140 fabric backplane communication
Figure 12: Fabric channel 2 connected to an internal network and fabric channel 1
connected to an external network
For the FortiGate-5001A boards to use the fabric channels for data
communication you must show backplane interfaces on the FortiGate web-based
manager and then configure firewall polices and routing for the fabric1 and fabric2
interfaces.
If the data traffic contains VLAN-tagged packets, you must add the VLAN tags to
the FortiSwitch-5003A interfaces that will handle the VLAN-tagged traffic. For
example, to allow VLAN tags 201 to 210 on slots 6, 8, and 10 and the F1 front
panel interface, from the FortiSwitch-5003A CLI enter:
config switch fabric-channel interface
edit "slot-6"
set allowed-vlans 1,201-210
next
edit "slot-8"
set allowed-vlans 1,201-210
next
edit "slot-10"
set allowed-vlans 1,201-210
next
edit "f1"
set allowed-vlans 1,201-210
end
Internal Network
FAN TRAY FAN TRAYFAN TRAY
1311975312468101214
5140
CRITICAL
RES
ET
MAJOR
MINOR
USE
R1
USER2
USE
R3
5140SAP
SERIAL 1 SERIAL 2 ALARM
FILTER
12
0
12
10/100
link/Act
ETH0
Service
RESET
STATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
10/100
link/Act
ETH0
Service
RESET
STATUS
Hot Swap
link/Act
ETH0
ETH1
10/100
5000SM
Fabric channel 1
data communication
Fabric channel 2
data communication
External network connected
to the F1 front panel fabric
interface to connect to
fabric channel 1
Internal network connected
to the F7 front panel fabric
interface to connect to
fabric channel 2
External
Network