Filter
Top Products
FortiController-5103B system Front panel LEDs and connectors
FortiController-5103B Session-Aware Load Balancer Guide
10-500-161552-20140822 7
http://docs.fortinet.com/
Front panel LEDs and connectors
From the FortiController-5103B font panel you can view the status of the board LEDs to
verify that the board is functioning normally. You also connect the FortiController-5103B
board to your 10-gigabit network using the 1 to 8 front panel SFP+ connectors. The front
panel also includes B1 and B2 connectors for the base channels, an Ethernet
management interface (MGMT), an RJ-45 console port for connecting to the
FortiController-5103B CLI and a USB port. The USB port can be used with any USB key
for backing up and restoring configuration files.
LEDs
FortiController-5103B front panel interfaces F1 to F8 appear on the
FortiController-5103B web-based manager and CLI as interfaces f1 to f8. In single
FortiController-5103B mode, workers see these as fctrl/1 to fctrl/8. In dual
FortiController-5103B mode, workers see these as fctrl1/1 to fctrl1/8 and fctrl2/1 to
fctrl2/8.
Table 2: FortiController-5103B LEDs
LED State Description
Fabric
(1/2 to 14)
Green Fabric backplane interface is connected at 10 Gbps or 1
Gbps. Backplane Fabric interface slot-14 is not
accessible.
Flashing
Green
Network activity at the fabric backplane interface.
Off No link is established.
Base (1/2 to 14)
Green Base backplane interface is connected at 1 Gbps.
Flashing
Green
Network activity at the base backplane interface.
Off No link is established.
OOS
(Out of Service)
Off Normal operation.
Amber A fault condition exists and the FortiController-5103B
blade is out of service (OOS). This LED may also flash
very briefly during normal startup.
PWR (Power) Green The FortiController-5103B board is powered on.
STA (Status)
Off The FortiController-5103B board is powered on.
Flashing
Green
The FortiController-5103B is starting up. If this LED is
flashing at any time other than system startup, a fault
condition may exist.
ACC (Disk
activity)
Off or
Flashing
green
The ACC LED flashes green when the
FortiController-5103B board accesses the flash disk. The
flash disk stores the current firmware build and
configuration files. The system accesses the flash disk
when starting up, during a firmware upgrade, or when an
administrator is using the CLI or GUI to change the
FortiController-5103B configuration. Under normal
operating conditions this LED flashes occasionally, but is
mostly off.