Filter
Top Products
Configuring the FortiWiFi NAT/Route mode installation
FortiWiFi-60A/AM FortiOS 3.0 MR4 Install Guide
01-30004-0283-20070215 39
Figure 7: NAT/Route mode connections
Configuring the networks
If you are running the FortiWiFi unit in NAT/Route mode, your networks must be
configured to route all Internet traffic to the IP address of the interface where the
networks are connected.
• For the internal network, change the default gateway address of all computers
and routers connected directly to your internal network to the IP address of the
FortiWiFi internal interface.
• For the DMZ network, change the default gateway address of all computers
and routers connected directly to your DMZ network to the IP address of the
FortiWiFi DMZ interface.
• For the WAN network, change the default gateway address of all computers
and routers connected to your WAN network to the IP address of the FortiWiFi
WAN interface.
• For the WLAN network, configure an IP address for the wireless local area
network interface.
If you are using the FortiWiFi unit as the DHCP server for your internal network,
configure the computers on your internal network for DHCP.
Make sure the connected FortiWiFi unit is functioning properly by connecting to
the Internet from a computer on the internal network. You should be able to
connect to any Internet address.
FortiWiFi-60AM
Internet
Router
Internal
network
DMZ network
Web Server
Mail Server
MODEM / DSL / Cable
Internal
DMZ
WAN1
WAN2
Wireless network