Filter
Top Products
FortiWiFi-60A/AM FortiOS 3.0 MR4 Install Guide
74 01-30004-0283-20070215
The FortiUSB key FortiWiFi Firmware
Using the USB Auto-Install feature
The USB Auto-Install feature automatically updates the FortiWiFi configuration file
and image file on a system reboot. Also, this feature provides you with an
additional backup if you are unable to save your system settings before shutting
down or rebooting your FortiWiFi unit.
You need to do the following before configuring the USB Auto-Install feature:
• power off the FortiWiFi unit
• install the FortiUSB key
• power up the FortiWiFi unit
The following procedures use both the web-based manager and the CLI.
However, it is recommended you use the CLI since the login screen may appear
before the installation is complete. The FortiWiFi unit may reboot twice if installing
the firmware image and configuration file.
To configure the USB Auto-Install using the web-based manager
1 Go to System > Maintenance > Backup and Restore.
2 Select the blue arrow to expand the Advanced options.
3 Select the following:
• On system restart, automatically update FortiWiFi configuration file if default
filename is available on the USB disk.
• On system restart, automatically update FortiWiFi firmware image if default
image is available on the USB disk.
4 Enter the configuration and image filenames or use the default configuration
filename (system.conf) and default image name (image.out).
5 The default configuration filename should show in the Default configuration file
name field.
6 Select Apply.
To configure the USB Auto-Install using the CLI
1 Log into the CLI.
2 Enter the following command:
config system auto-install
set default-config-file <filename>
set auto-intall-config <enable/disable>
set default-image-file <filename>
set auto-install-image <enable/disable>
end
3 Enter the following command to see the new firmware installation settings:
get system status
Note: You need an unencrypted configuration file for this feature. Also the default files,
image.out and fgt_system.conf, must be in the root directory.
Note: Make sure FortiOS v3.0MR1 is installed on the FortiWiFi unit before installing.