Filter
Top Products
freeStor Mini 210/310 User’s Manual
5
3. Remove the end cover and pull the hard drive tray out of the enclosure (Figure 7).
Figure 7: Removing the Tray
4. Set the jumpers on the hard drive to “Master” mode (refer to the documentation of your hard
drive for details).Connect the power cable from the tray to the hard drive.
5. Connect the power cable from the tray to the hard drive and insert the hard drive into the
tray label side up, ensuring that the IDE connection is secure (Figure 8).
Figure 8: Inserting the Hard Drive
6. Attach the screws to the hard drive to hold it in place (Figure 9).
Figure 9: Attaching the Hard Drive Screws
Note: If the IDE connector or screw holes on the bottom of the tray do not line up
properly, you can move them by loosening the screw that holds the board in
place (Figure 10). After adjusting the position of the board, tighten the screw to
hold the board in place.