![](http://pdfasset.owneriq.net/6/ba/6bab0dbf-5117-4aa9-9d6d-d724c51b85ad/6bab0dbf-5117-4aa9-9d6d-d724c51b85ad-bg10f.png)
HC08 Full Chip Simulation
Configuration Procedure
271
Microcontrollers Debugger Manual
INPUT<x> Command
The INPUT<x> command sets the simulated inputs to port <x>. The CPU reads this input
value when port <x> is set as an input port.
Syntax
>INPUT<x> <n>
Where:
<x> is the letter representing corresponding port
<n> Eight-bit simulated value for port <x>
Example
>INPUTA AA
Simulate the input AA on port A.
INPUTS Command
In Full Chip Simulation and CPU-Only Simulation mode, the INPUTS command opens
the Simulated Port Inputs dialog box shown in Figure 11.22
. You may then use this box to
specify the input states of port pins and IRQ.
Figure 11.22 Simulated Port Inputs Dialog Box
When using In-Circuit Simulation mode, the INPUTS command shows the simulated
input values to any applicable port.
Syntax
>INPUTS