![](http://pdfasset.owneriq.net/6/ba/6bab0dbf-5117-4aa9-9d6d-d724c51b85ad/6bab0dbf-5117-4aa9-9d6d-d724c51b85ad-bg1c1.png)
HCS08 Full Chip Simulation
Peripheral Modules Commands
449
Microcontrollers Debugger Manual
IRQ Commands
The following interrupt request command is available for the HCS08.
INPUTS Command
In FCS and CPU-Only Simulation mode, the INPUTS command opens the Simulated Port
Inputs dialog box shown in Figure 18.21
. The user may then use this box to specify the
input states of port pins and IRQ.
Figure 18.21 Simulated Port Inputs Dialog Box
When using In-Circuit Simulation mode, the INPUTS command shows the simulated
input values to any applicable port.
Syntax
>INPUTS
Example
>INPUTS
Show I/O port input values.
NOTE The IRQ pin state can be directly manipulated with the IRQ command. For
example, IRQ 1 simulates a high state on the IRQ pin; likewise, IRQ 0
simulates a logic-low state on the IRQ pin.