Filter
Top Products
35
■ Replacing a internal hard disk equipped as standard
This section explains how to replace a standard-equipped internal hard disk with a hard disk of
larger capacity.
1
Set up the jumper switch.
See the manual accompanying the internal hard
disk and make sure that the jumper switch has
been set to master, or cable select.
2
If retaining metal brackets are mounted on
both sides of the internal hard disk to be
replaced, remove them.
Remove the screws (4) to remove the retaining
metal brackets.
3
Remove the upper cover.
4
Disconnect the hard disk cables.
Disconnect the power cord and flat cables
connected to the hard disk.
5
Remove the retaining metal bracket.
Remove the screw (one), then remove the
retaining metal bracket by sliding it in the
direction of arrow
1
, then arrow
2
, and then lift
it in the direction of arrow
3
.
2
1
3