Filter
Top Products
47
Error Message
An invalid hard disk drive was set.
Turn the power off, then on again.
Confirm BIOS setup items, then
save.
Because the computer was not
booted correctly last time, some
of the setup values are reset to
defaults.
If an error occurs during POST,
this message is displayed before
the OS boots.
Check date and time settings
Description and necessary action
Confirm ‘Primary master’ or ‘Secondary master’ on the
BIOS setup main menu. If the message is still displayed,
contact a dealer or the your local distributor.
If the message is still displayed, contact a dealer or the
your local distributor.
If the message is still displayed, contact a dealer or the
your local distributor.
This message is displayed if an invalid BIOS setup value
is defined to boot the system, the power is turned off
during boot, or the computer is rebooted three or more
times in the same operation. To continue booting, press
the F1 key. To run the BIOS setup utility and check setup
values, press the F2 key.
To boot booting the OS, press the F1 key. To run the BIOS
setup utility and change setup values, press the F2 key.
Confirm 'System Time' and 'System Date.'