Filter
Top Products
39
9
Connect the flat cable.
Connect the flat cable that is appropriate for the
internal option to be installed.
- To install two IDE-standard internal options to
the IDE secondary cable (if one of the options
is a hard disk), install the hard disk at the
master side.
- To install a SCSI interface internal option:
Connect the flat cable to the SCSI card in the
expansion slot.
- To install a floppy disk drive:
Connect the flat cable to the expansion card
of the internal floppy disk drive in the
expansion slot.
10
Connect the power cord.
Connect the unused power cord to the
connector of the installed internal option.
Connected to the riser board
Connected when set to the slave
Connected when set to the master
SLAVEMASTER
Blue or red line
Pin 1