Filter
Top Products
34
− Enable Scanner Panel
This is to specify whether the operator panel is enabled or not. If this is checked, button
operation on the operator panel becomes effective.
− Enable Scanner Dial
Specifies whether the value indicated by the density dial on the scanner is reflected on
scanning or not.
This setting is valid when both “Enable Scanner Panel” and this checkbox are checked.
With this density dial, the density can be set by five levels.
If moving the density dial to the UP direction, the density changes [Normal] >>[Darker
scanning]>>[Dark scanning]. If moving the density dial to the Down direction, the
density changes [Normal]>>[Lighter scanning]>>[Light scanning]. If the dial is in the
center, the scanning density is [Normal].
− Enable [Duplex] button
This specifies whether the [Duplex] button (to switch simplex and duplex) on the
scanner operator panel is reflected to the scanning.
If this box is checked, scanning changes [Simplex] >> [Duplex]>> [Simplex] with the
[Duplex] button is pressed.
− Enable [Send to] button
Specifies whether the preview is started by pressing the [Send to] button on the device.
− Enable ADF Scanning Start
Specifies whether ADF auto feed is started by a scanner event.
◊ [Scan] button
Pressing the [Scan] button on the scanner starts scanning from the ADF.
◊ Document Detection
When paper is detected on the ADF, scanning automatically starts.