Filter
Top Products
81
8.2 Device Trouble Related to Operation
• The [Scan] button is pressed, but scanning is not performed.
Cause: Has the scanner power been turned on? Has the SCSI cable been
connected correctly? Has the correct device type been selected using
[Select TWAIN Input Device]?
• The scanner appears to be operating, but no image is displayed.
Cause: Has the SCSI cable between the scanner and the main unit been
connected correctly?
Is the [Brightness] value or [Threshold] value too small?
When the [Minimize] button is pressed, is the [Restore] button
displayed?
Is the application set to perform only file output?
User response: If the [Restore] button is displayed after the [Minimize] button is
pressed, the problem could be the display driver that is being used.
Contact the manufacturer of the display driver.
If a file has been selected as output destination with the environment
settings by the image scanner operation confirmation utility, try to
change to screen output.
• When the ADF is used for scanning, scanning terminates without the paper jam error
message being output.
Cause: Do the settings specify to suppress the output of error messages?
User response: After an environment setting utility error message is output, select
[Show Error Message].