Filter
Top Products
66
•
The current parameter(s) is (are) not allowed. Please use (an)other parameter(s) and try
scanning again.
Cause: An incorrect value has been specified for the image scanner. The
problem may be due to an illegal combination with the specification
value from the application.
User response: Change the specification values. Then, try scanning again.
•
The scanner is in an irregular status; fuse is broken, etc. Please check the scanner status.
Cause: A scanner fault such as a blown fuse or foreign matter in the scanning
section has occurred.
User response: Check the scanner status. If a fuse has blown, replace the fuse. If
there is foreign matter in the scanning section, remove the foreign
matter. If the error persists, contact the retail store where the image
scanner was purchased or the nearest maintenance and service center.
•
Memory is insufficient.
Cause: Insufficient memory for scanning. The memory available may be
insufficient because an application consuming much GDI memory is
operating, too many other programs operate at the same time, or there
are too many registered device drivers. The user may mistakenly
think that adding more memory will solve this problem. However, in
most cases, memory shortage is due to insufficient conventional
memory (called the main memory within 640 kilobytes). Checking
CONFIG.SYS and AUTOEXEC.BAT may be a better solution.
User response: Cancel the registration of device drivers that are irrelevant and make
sure that only the absolutely necessary programs are operating. Use
the memory optimization tool to allocate as much conventional
memory as possible.
•
An error occurred in the temporary file.
Cause: Accessing the internal temporary file of the scanned image is causing
the error. The disk space may be insufficient, the temporary file may
be damaged, or other programs may be affecting disk access.
User response: Increase the free space of the disk. Check the hard disk (chkdsk and
scandsk). Make sure that no other program is accessing the disk. If
the error message persists, contact the retail store where the product
was purchased or the nearest service center.
•
Download file not found.
Cause: A file specified as a dither pattern or gamma pattern cannot be found.
User response: Check that the download file is in the specified directory. Otherwise,
use the file selection dialog to specify an available file.