Filter
Top Products
71
•
Scanner could not find although it searched again. Check the connection of the scanner and
retry again
Cause: The scanner power may not have been turned on or the cable may
have been connected incorrectly. Otherwise, the OS may not
recognize the scanner.
User response: Make sure that the scanner power has been turned on and the cable
has been connected correctly, then retry rescanning. Or, check if the
OS recognizes the scanner. If the OS does not recognize it, let it
recognize the scanner, then retry.
•
Can not rescan the scanner.Close the application using the driver and retry again
Cause: An attempt was made to rescan while the driver was in use.
User response: It is impossible to rescan while the driver is in use. Close the
application that uses the driver and retry.
•
Can not get the EEPROM data. The setting of the function key can not change. Check the
connection of the scanner
•
Can not change the setting of the function key.Check the connection of the scanner and try
the operation again
Cause: While the scanner with function keys are being monitored, the scanner
power may be turned off or the cable may be connected incorrectly.
User response: Make sure that the scanner power has been turned on and the cable
has been connected correctly.
•
It is not authorized to write into the folder which is installed FUJITSU Scanner Control
Center. Can not change the function of the function key. Check the Access Authority of the
folder which is installed FUJITSU Scanner Control Center.
Cause: While the scanner with function keys are being monitored, Access
Authority may not have been set to the folder where the FUJITSU
scanner Control Center has been installed.
User response: To change the setting of the function key, Access Authority of the
folder where FUJITSU scanner Control Center has been installed is
required. Set Access Authority to the folder where FUJITSU scanner
Control Center has been installed, or execute it with Administrator
Authority.
•
Scanner is not selected. Please select a scanner
Cause: The OK button was pressed without selecting the scanner in the
scanner select dialog.
User response: Press the OK button after selecting the scanner to be monitored.