Filter
Top Products
Add-on modules
20 - English A26361-D1419-Z120-1-7419
11
1
1
1
When using a new heat sink:
Ê Remove the protection cover from the
underside of the heat sink.
When using the previous heat sink:
Ê Completely remove the old residues of the
heat conducting paste.
Ê Apply an even coat of heat conducting paste
to the entire surface of the processor and
mount the heat sink on it.
Ê Fix the heat sink with the supplied screws.
Ê Connect the end of the fan cable to the
connector on the mainboard.
Upgrading main memory
The slots for the main memory are suitable for 256, 512, 1024 and 2048 Mbyte DDR-DIMM memory
modules. The organization in three memory banks 0 to 2 enables fast memory access with
interleave. The board supports a maximum of 12 Gbytes.
Two identical memory modules must be installed per memory bank. Partial equipping of a memory
bank is not possible. The equipping sequence of the memory banks is arbitrary.
!
You may only use registered DDR DIMM memory modules. Unbuffered memory modules
are not permitted.
DDR DIMM memory modules must be designed for a clock frequency of 266 MHz
(meets PC2100 specification).