Fujitsu DX90 S2 Computer Drive User Manual


 
Chapter 3 Connections
3.4 Power Supply Connection
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Site Planning-
Copyright 2013 FUJITSU LIMITED P3AM-4822-12ENZ0
56
LAN for operation management
In an ETERNUS DX Disk storage system, the system administrator logs on to the ETERNUS DX Disk storage
system via a LAN to set the RAID configuration, manage operations, and perform maintenance. The computer
for operation management that is used for accessing the ETERNUS DX Disk storage system via ETERNUS Web
GUI or ETERNUS CLI is called an administration terminal.
In addition, the functions that are provided by the management/monitoring server on the LAN can be used.
These functions include SNMP (device monitoring), SMTP (e-mail sending), NTP (time correction), syslog
(event notification and audit log sending), RADIUS (user authentication), and KMIP(key management).
LAN for remote support
Various failures that occur in the ETERNUS DX Disk storage system are notified to the remote support center.
Remote support connection can be separated from the LAN for operation management.
3.4 Power Supply Connection
Connect the power cords (AC cables) of the ETERNUS DX Disk storage system to the power sockets, the UPS
sockets, or the power control unit sockets.
Refer to "2.6 Outlet/Socket Specifications" (page 37)
for details about the types and the number of power
outlets/sockets.
The following items are supported in firmware version V10L30 or later:
Internet Explorer 9.0
Firefox ESR 10.0.x
IPv6
The following item is supported in firmware version V10L40 or later:
Internet Explorer 10.0 (desktop version)
The following item is supported in firmware version V10L45 or later:
Firefox ESR 17.0.x
Two power supply units (PSU#0 and PSU#1) are installed in each enclosure. Make sure that power cords are
connected to both of the power supply units.