Filter
Top Products
6
1.2 Loading Documents on the ADF for Scanning
1. Align the edges of the documents.
1) Confirm that all the documents have the same width.
2) Check the number of the sheets in the document stack.
The standard number of sheets that can be loaded on the scanner is as follows:
• A4-size paper or smaller that makes a document stack of 10mm or less (100 sheets
at 80 g/m
2
or at 20 lb)
• Over A4-size paper that makes a document stack of 5mm or less (50 sheets at
80 g/m
2
or at 20 lb)
2. Fan the documents as follows:
1) Lightly grip both ends of the documents with both hands, and bend the documents as fol-
lows.
2) Hold the documents firmly with both hands and bend them back as follows so that the
bent section rises up in the middle of the stack as shown below.
3) Repeat steps 1) and 2) a couple of times.
4) Rotate documents 90 degrees, and fan again.
3. Align the top of the documents.
HINT
For details about document specifications for ADF, refer to Chapter6 "DOC-
UMENT SPECIFICATIONS FOR ADF" (page 101).