Filter
Top Products
58
• Feed and Eject rollers
1) Open the ADF when the indication of the Function Number display is not "P" or
"0".
If you open the ADF when the indication of the Function Number display is "P" or
"0", the Feed rollers / Eject rollers will not rotate even you perform the operation
of step 2) below.
2) Simultaneously hold down the "Send to" and "Scan" buttons on the operator panel.
The Feed rollers / Eject rollers start to rotate slowly.
3) Hold a soft, dry cloth moistened with cleaning fluid against the surface of the rotat-
ing Feed rollers / Eject rollers so that it lightly cleans the surface of the rollers.
As a guideline, 7 presses of the "Send to" and "Scan" buttons make the Feed rollers
/Eject rollers to rotate one full turn.
• Plastic rollers
Clean the Plastic rollers lightly, not to roughen the roller surfaces. Take particular care in
cleaning these rollers as black debris on them adeversely affects the pickup performance.
Be careful not to damage the sponges beside the rollers.
• Sheet guides
Clean lightly.
• Glass
Clean lightly.
• Ultra sonic sensor
Clean lightly with a dry cloth.
In step 2), the Feed rollers turn at the same time while
rotating the Eject rollers.
When cleaning the Eject rollers, be careful not to touch
the Feed rollers and vice versa.
ATTENTION
If the glass is dirty, vertical black streaks may apper in the scanned
images.
Function No.
display
Function
Send to
Scan
LED
Power button