Filter
Top Products
Chapter 2 Access Control 13
FIGURE 2-2 Operator Panel on a High-end Server
You must toggle the MODE switch within one minute of the login prompt or the
login process times out.
2. Toggle the MODE switch using one of two methods, as follows:
■ If the switch is in the Service position, turn it to the Locked position, leave it there
for at least five seconds, and then turn it back to the Service position. Press the
Enter key.
■ If the switch is in the Locked position, turn it to the Service position, leave it there
for at least five seconds, and then turn it back to the Locked position. Press the
Enter key.
When the toggling is successful, you are logged in to the Service Processor shell as
the account default.
As this account has useradm and platadm privileges. you can now configure the
Service Processor or reset passwords.
When the shell session ends, the default account is disabled. When an account is
disabled, it cannot be used to log in at the console. It will then not be possible to
login using this account again except by following this same procedure.
XSCF>