Filter
Top Products
42 SPARC Enterprise Mx000 Servers Administration Guide • April 2007
▼ To Enable or Disable the Service Processor
Telnet Service
1. Log in to the XSCF console with platadm privileges.
2. Optionally, display the current status of the Service Processor Telnet Service:
3. Type the settelnet command:
where function is either enable or disable. The Telnet service starts immediately
after being enabled, and stops immediately after being disabled.
▼ To Configure the Service Processor SMTP
Service
1. Log in to the XSCF console with platadm privileges.
2. Optionally, display the current status of the Service Processor SMTP Service:
3. Type the setsmtp command:
You are prompted to enter the name of the SMTP mail server to be used, the port
number to be used (default is port 25), the authentication mechanism (default is
none) and the Reply Address. You must specify a valid email address.
▼ To Enable or Disable the Service Processor SSH
Service
1. Log in to the XSCF console with platadm privileges.
XSCF> showtelnet
XSCF> settelnet -c function
XSCF> showsmtp
XSCF> setsmtp