Filter
Top Products
Chapter 3 System Configuration 31
2. Type the setroute command:
where -c specifies whether to add or delete routing information, -n address specifies
the IP address to which routing information is forwarded, -m address specifies the
netmask address to which routing information is forwarded, -g address specifies the
gateway address, and interface specifies the network interface to be set with routing
information. Refer to
TABLE 3-1 for valid interface names.
For additional information on the setroute command, including specifying
takeover IP addresses, refer to the setroute(8) man page or to the SPARC Enterprise
M4000/M5000/M8000/M9000 Servers XSCF User’s Guide.
▼ To Set Or Reset the XSCF Network
When you set or change the Service Processor host name, DNS domain name, DNS
server, IP address, netmask, or routing information, the settings must be applied to
XSCF, and the Service Processor must be reset, before the settings become effective.
1. Log in to the XSCF console with platadm privileges.
2. Type the applynetwork command:
The applynetwork command displays the information that has been set for the
XSCF network, and asks you to reset the Service Processor. The Service Processor
must be reset for settings to become effective.
3. Verify the operation with the shownetwork command.
▼ To Display XSCF Network Configuration
1. Log in to the XSCF console.
XSCF> setroute -c [add|del] -n address [-m address] [-g address] interface
XSCF> applynetwork