Filter
Top Products
26
Stylistic ST4000P Series User’s Guide – Section Two
Installing a Memory Module
To install a DIMM module in the pen tablet PC:
1. Ensure that the pen tablet PC is off. To do so, carry
out the Shut Down command in the Start menu.
(Do not attempt to remove or install a DIMM
module when the system is in Suspend mode or
running.)
2. Remove the two screws from the cover plate on the
back of the pen tablet PC and remove the cover plate
as shown in Figure 2-5.
Figure 2-5 Accessing the Memory Slot
3. Insert the DIMM module in the socket at an angle
and push it down until it locks into place as shown
in Figure 2-6. Note that the DIMM module is keyed
to prevent it from being inserted backwards.
Figure 2-6 Installing a DIMM Module
4. Reinstall the cover and screws that you removed in
step 2.
5. Confirm that the DIMM module is recognized by
the system. To do so, run BIOS Setup. The size of
the DIMM module should be displayed in the Info
menu in BIOS Setup.
The DIMM module is installed in the pen tablet PC and
you can now use the system.
Removing a Memory Module
To remove a DIMM module:
1. Ensure that the pen tablet PC is off. To do so, carry
out the Shut Down command in the Start menu.
(Do not attempt to remove or install a DIMM
module when the system is in Suspend mode or
running.)
2. Remove the screws from the cover plate on the back
of the pen tablet PC and remove the cover plate as
shown in Figure 2-5.
3. Spread the fingers on the socket that lock the DIMM
module in place until the DIMM module is loose.
4. Remove the DIMM module from the socket.
The DIMM module is now removed from the pen tablet
PC. Refer to “Installing a Memory Module” on page 26
to install a new DIMM module.
CAUTION
DIMM replacement should only be performed at a
static-free workstation. Avoid touching connector pins,
circuit boards, and other circuit components on the
drive or pen tablet PC. Electrostatic discharge caused by
doing so can damage sensitive components.
Alb_UG.book Page 26 Friday, November 1, 2002 4:22 PM