Filter
Top Products
5-12 SPARC Enterprise T1000 Server Service Manual • April 2007
You should see output similar to the following:
■ If you see the following output:
■ Firmware version v1.a.0.0 or higher (for example, v1.b.0.0,
v1.c.0.0, and so on), or
■ Firmware version v1.10.0.0 or higher (for example, v1.11.0.0,
v1.12.0.0, and so on)
then you have the latest drive controller firmware. Go to Step 17.
■ If you see the text Firmware version v1.6.0.0 in the output, then you have
an older version of the drive controller firmware.
Once the patch has been installed, your system will have the latest drive
controller firmware.
17. Perform the necessary administrative tasks to reconfigure the hard drive.
The procedures that you perform at this point depend on how your data is
configured. You might need to partition the drive, create file systems, load data from
backups, or have the data updated from a RAID configuration.
5.5 Replacing a Hard Drive
■ To remove a hard drive from a single-drive assembly, go to Section 5.5.1,
“Replacing a Hard Drive in a Single-Drive Assembly” on page 5-12.
■ To remove a hard drive from a dual-drive assembly, go to Section 5.5.2, “Replacing
a Hard Drive in a Dual-Drive Assembly” on page 5-15.
5.5.1 Replacing a Hard Drive in a Single-Drive
Assembly
5.5.1.1 Removing the Hard Drive in a Single-Drive Assembly
1. Perform the procedures described in Chapter 4.
Jun 7 13:23:16 wgs57-57 genunix: [ID 540533 kern.notice] SunOS Release 5.10
Version Generic_118833-08 64-bit
Jun 7 13:23:16 wgs57-57 mpt0 Firmware version v1.a.0.0 (IR)