Filter
Top Products
Chapter 5 Replacing Field-Replaceable Units 5-7
FIGURE 5-5 Installing the Power Supply
4. Redress the power cable through the midwall in the chassis and connect the cable
to the motherboard.
5. Perform the procedures described in Chapter 6.
6. At the sc> prompt, issue the showenvironment command to verify the status of
the power supply.
5.4 Replacing the Hard Drive Assembly
5.4.1 Removing the Single-Drive Assembly
1. Disconnect the drive cable from the data/power connector at the rear of the hard
drive (
FIGURE 5-6).
2. Pull the fasteners up on the rear of the single-drive assembly, and remove the
single-drive assembly from the chassis (
FIGURE 5-6).
Power supply
Fastener