Filter
Top Products
1. OVERVIEW, SETUP
1-10
1.3.2 How to use FAX-30 with NavNet 3D
Connect the FAX-30 to the NavNet 3D. If the IP address of the FAX-30 has been
changed, restore the IP address to [172.31.8.1]. For how to open the installation
wizard, see the installation manual for the NavNet 3D.
1. Turn on the FAX-30 at the switchboard. (The FAX-30 does not have a power
switch.) Check if the power is on or the unit is disconnected, by monitoring
the LED.
a) The initialization of the FAX-30 takes approximately 15 seconds.
b) Data is transferred from the ROM to the RAM. At this time the LED flashes
every 0.4 seconds.
c) It takes about two minutes to send data. The LED blinks every two seconds
when the FAX-30 is available for operation.
2. Push the [DISP] key.
3. Push the RotoKey
TM
until the display selection window, shown below,
appears.
Full screen icon
Weather icon