Filter
Top Products
GBC 4064WF-1 Operation Manual
© 2009 GBC an ACCO Brands Co. Page 7
FRONT CONTROL GUIDE
FIGURE 1.
1. LCD:
• The LCD will display the settings the machine is
currently set for.
• Illuminates when the laminator is plugged in and
POWER ON/OFF is in the on, (I), position.
Displays settings for the top heater, bottom heater,
speed, job mode, and ready/wait.
• TOP: -refers to the Top Main Rollers temperatures
setting.
• BOT: - refers to the Bottom Main Rollers
temperatures setting.
• Mode: -Displays the current Machines Mode. It will
read either FWD or REV.
• Speed: Will display the set speed.
• POS: Will indicate the roll gap or position.
2. Top Set Temp:
• This will display the “Set Temp.” of the Top
Main Roller.
3. Bottom Set Temp:
• This will display the “Set Temp.” of the Bottom
Main Roller.
4. Speed:
• This will display the “Set Speed.” of the
Laminator.
5. Job Mode:
• When pressed, the Job Selection will activate.
By rotating the Master Dial, You can select the
Job Needed. When Job Save is pressed and held,
the current job settings will save for that Job.
6. Master Dial:
• Increases (+) or decreases (-) the numeric value
for the selected setting when turned. Navigates
through the Job Selections.
7. Front Roller Press:
• When pressed, the Main Rollers will move to the
Press or Down position.
8. Front Roller Release:
• When pressed, Top Main Roller will move to the
Up or Release position.
9. Reset:
• When pressed, the counter will reset to “0”.
10. Rear Roller Press:
• When pressed, The Pull Roller or Rear Roller
will move to the Press or Down position.
11. Rear Roller Release:
• When pressed, The Pull Roller or Rear Roller
will move to the Release or Up position.
12. Cooling:
•
When pressed, The Cooling Fans will Turn On.
When pressed again, they will turn Off.
13. Start:
• When pressed, The Pull rollers or Rear Roller
will move to the Press or Down Position.
14. Stop:
• When pressed, The Rollers will stop rotating.
15. Direction:
• When pressed, the direction of the machine can
be changed. Forward and Reverse.