Filter
Top Products
GBC 4064WF-1 Operation Manual
© 2009 GBC an ACCO Brands Co. Page 8
There are 2 Lamination Processes on 4064WF-1, LAM and ACCUSHIELD.
LAM:
This setting is intended to be used when an operator wants to use both the top and bottom
heater, and wants full downward pressure on the Main Rolls.
To Select a Different Pressure or Gap:
Press STOP to stop the machine.
Press JOB.
Rotate the MASTER DIAL.
The Pressure and Gap selections are: LAM, 0”, 1/16”, 1/8”, 3/16”, ¼”, 3/8”, ½”, ¾”, 1”
FIGURE 1.
.
FIGURE 1 shows:
Top and Bottom heat is set to 32*
Position of the Rollers are Set at the highest downward pressure.
The distance this machine ran since being reset is 36ft.
WAIT indicates the machine is out of the range of the set temp.
Speed is set for 7ft/mn
The direction of the laminator is set to go forward.
FIGURE 2.
FIGURE 2 shows:
The Top Heat has been set to 220*F
The Bottom Heat has been set to 115*F
Position of the Rollers are Set at the highest downward pressure.
The distance this machine ran since being reset is 36ft.
READY Indicates that the temperature has reach the desired set-temp.
Speed is set for 7ft/mn
The direction of the laminator is set to go forward.