Filter
Top Products
Page 4-2 © 2004 General Binding Corporation
Operations ManualPolaris II
4.2 Setting up your laminator
After placing your Polaris laminator, the catch table must
be installed.
1. To assist in the installation of the catch table, a set of
tools has been provided. The tools are sent with the
machine and can be found wrapped up on the front feed
table.
2. Locate rear feed table and inspect for any damages
that may have been caused during shipping. Locate Four
bolts, two C-clamps, two flat mounting plates, two legs,
and four nuts.
3. Place the table leg between the C-clamp and the flat
mounting plate. Secure the legs to the table using bolts
and nuts. NOTE: These legs may have been pre-
assembled at the factory.
4. At this time the feed table legs can be adjusted to
desired height (approx 16”). Table height (angle) depends
on the paper stock being laminated. Tighten nuts.
5. After the feed table is set to desired height, mount the
table on the machine using the front table hooks. To apply
the rear catch table, first locate the catch table support
bar located at the rear of the machine. The catch table
hooks directly to the catch table support bar
6. At this time the paper guides can be mounted onto the
catch table. See Figure 4.2.1.
Figure 4.2.1 Paper Guide
CATCH TABLE
PAPER GUIDE
Once the catch table is in place, connect the air/ vaccum
pump (rated 230V@ 10 Amps or less) to the receptacle
located under the separator. The receptacal is identified
by the label shown below.
Refer to Section 3.5 Electrical requirements