Filter
Top Products
Page 7-3 © 2004 General Binding Corporation
Operations Manual Polaris II
Laminator won’t run. Verify that unit is plugged in and power is present.
Check control panel for machine status.
Check fuses.
Feed pile light must be on.
Feeder not picking up sheets. Check pick up heads.
Check suction at pick up heads.
Check air blast.
Check pile height proximity switch.
Insure that paper is properly stacked and fanned.
Feeder head not moving. Check fuse.
Verify sheet feed eye (1st eye) is clean.
Sheets not feeding straight. Check Pile Height pinching leading edge under tray
Check for uneven pressure on in-feed rollers.
Check side guides on table.
Check for obstructions on in-feed plate.
Check Air Blast
Sheets wrinkled. Film tension not set properly.
Adhesive or paper on rollers.
Roller pressure uneven.
Crooked infeed.
Pull out roller pressure uneven.
Film stretching or shrinking. Speed too slow.
Film tension too high.
Film tension too high on core chuck.
Binding of core chuck on shaft.
Film not sticking. Machine not up to heat.
Running too fast.
Nip roller pressure not set properly.
Using incorrect film.
Excessive upward curl. Brake or film tension set too high.
Decurling bar not set properly.
Excessive downward curl. Decurling bar not set properly.
Cutter not cutting. Cutter not in home position.
Check fuse.
Cutter and detector out of alignment with film web.
Film web to close too edge of paper.
Web running over blade.
Overlap too small
Use paper pin
Sheets not exiting the back of the machine. Check fuse.
Pressure on pull out rollers not set properly.
Obstructions in cutter area.
Use exit clips.
Sheet not flat.
Symptom Solution
Figure 7.3.1 Troubleshooting guide