Filter
Top Products
Page 7-2 © 2004 General Binding Corporation
Operations ManualPolaris II
7.4 Troubleshooting
As an operator, you can perform some basic
troubleshooting before contacting your local service
representative.
WARNING: Never remove the side panels in
attempt to troubleshoot the laminator. You may cause
damge to other components or injury to yourself.
WARNING HAZARD: Do not open the side panels.
You will be exposed to dangerous voltage which can
shock.
CAUTION: Only trained technicians should perform
service related work on the laminator.
Refer to Figure 7.3.1 Troubleshooting Guide on page
7-3.
1. Remove the film from the laminator.
2. Preheat the laminator to 240 deg. F.
3. Rub the top and bottom heat rollers with a clean, lint
free cloth and mineral spirits.
4. Use the “Inching” funcion to rotate the heat rollers to a
new area for cleaning. Continue this process until the
complete surface of both rollers are clean.
5. Use a damp cloth to clean the teflon roller.
7.3 Misc maintenance
-
Clean and lubricate chains with standard chain lubricant
four times per year.
- Lubricate the gear reducers once a year with standard
grease.
- Inspect and replace the suction cups as needed.
- Follow the recomended maintenance for the Becker air
pump, as provided in the Becker instruction sheet.