Filter
Top Products
Page 5-2 © 2004 General Binding Corporation
Operations ManualPolaris II
(7) CATCH TABLE: The catch table is located at the
rear of the machine and collects finished sheets. See
Figure 5.1.3.
Figure 5.1.3 Catch Table
CATCH TABLE
(8) VACUUM AND BLOWER ADJUSTMENT
KNOBS: The vacuum to the suction cups and the pile
blower can be controlled by increasing or decreasing air
adjustment knob of your compressor. See Fuigure 5.1.4.
Figure 5.1.4 Vacuum Adjustment
VACUUM AND BLOWER
ADJUSTMENT KNOBS
(9) AIR GAUGE & REGULATOR AND VACUUM
GAUGE: The air pressure gauge and regulator indicate
and control the amount of air being blown into the feeder
stack.
The vacuum gauge indicates how much suction is applied
to the suction assembly. See Figure 5.1.5.
Figure 5.1.5 Air and Vacuum Gauges
AIR GAUGE
AIR REGULATOR
VACUUM GAUGE
(10) GUIDE WHEELS: The guide wheels assist in the
entering and exiting of sheets. The guide wheels should
be adjusted prior to running a job. Adjustments may have
to be made as jobs change. The guide wheels are to be
equally spaced to fit on the sheet to be run. See Figure
5.1.6.
Figure 5.1.6 Guide Wheels
GUIDE WHEELS