Filter
Top Products
2.2.8 Snmp command group
The snmp command group allows to configure the SNMP Agent for UPS monitoring via SNMP and trap
notification of UPS events and alarms:
Command Parameters Description
showsnmp Show detailed system information
snmpport [port]
Set SNMP server listening port (*)
[port] SNMP port
NOTE: Default SNMP port is 161.
snmp-server on | off
Enable/disable SNMP Agent
on SNMP Agent enabled
off SNMP Agent disabled
syscontact [contact] (**)
Set the system contact
[contact] contact person
NOTE: The syscontact parameter is the identification of
the contact person for the managed node.
syslocation [location] (**)
Set the system location
[location] location name
NOTE: The syslocation parameter is the identification of
the physical location of the managed node.
Defines the community name for receiving SNMP
information (GET).
[community] community name
[community] getcommunity
NOTE: The get community name controls access to the
SNMP Agent – the community in the request must match
the getcommunity parameter.
The default value is public.
Defines the community name for writing SNMP
information (SET).
[community] community name
NOTE: The set community name controls access to the
SNMP Agent – the community in the request must match
the setcommunity parameter.
The default value is private.
setcommunity [community]
(*) Changing the port causes the SNMP Agent to restart. This might have a temporary effect also on trap
notification.
(**) Both parameters have a maximum length of 63 chars. If these parameters contain blanks or special
characters they shall be specified in between double quotation marks (“...”) .
Modifications reserved Page 21/58
OPM_CNT_SNM_BAS_CRD_1GB_V012.doc Operating Manual SNMP/Web Adapter