Filter
Top Products
2.2.9 Trap command group
The trap command group allows to configure the trap sending functionality. With SNMP traps various
systems can be notified in case of UPS events and alarms.
Command Parameters Description
showtrap Show detailed trap configuration
sendtrap on | off
Enable/disable send trap [RFC1628] function
on Trap sending enabled
off Trap sending disabled
sendgetrap
Enable/disable send trap [GE-MIB] function
on Trap sending enabled
off Trap sending disabled
on | off
NOTE: 3-ph version ONLY
addtraptgt
[X.X.X.X]
v1 | v2
[community]
[port]
Add a trap address
[X.X.X.X] IP-address of the trap target
v1 | v2 SNMP version
(optional – default: v1)
[community] community name
(optional – default: public)
[port] port to which the trap will be sent
(optional – default 162)
NOTE: Maximum 20 recipients can be defined.
deltraptgt
Delete a trap address
[X.X.X.X] IP-address of the trap target
[X.X.X.X]
Modifications reserved Page 22/58
OPM_CNT_SNM_BAS_CRD_1GB_V012.doc Operating Manual SNMP/Web Adapter