Filter
Top Products
SOFTWARE OVERVIEW
P485 MODBUS TO PROFIBUS CONVERTER – USER GUIDE 4–11
OPTIONS WINDOW In the main window under tools, select options.
Fieldbus configuration
DESCRIPTION During start-up, the fieldbus interface is initialized to fit the configuration created in the
EnerVista P485/D485 Setup software. Since EnerVista P485/D485 Setup supports both the
P485 and D485 converters, the user must verify that the 'Fieldbus' parameter indicates the
correct converter. Additionally, it is possible for advanced users to customize the network
interface inside the converter to meet specific application demands (see Advanced fieldbus
configuration on page 8–5 for details).
Figure 4-5: Fieldbus configuration
Table 4–1: Options window functions
Function Description
Warning on delete When something is to be deleted, a warning window will appear.
Warning on unsaved
data
When closing EnerVista P485/D485 Setup with unsaved data, a
warning window will appear.
Show Wizard when
“New” menu is selected
Each time a new configuration is to be made, the Wizard window will
appear.
Language next time the
program is launched
Select which language the program should use the next time the
program is launched. Presently, only English is supported.
Size of log buffer Set the size of the log buffer (0 to 512 bytes).
Firmware download Download the firmware to the
P485. Use with caution.
Factory restore Restores the software on the P485 carrier board, to it´s original state.
Block configuration Use with caution. When this button is pressed, the configuration will
not be accessible and a new configuration has to be downloaded to
the module.
Create error log Creates an error log file.