Filter
Top Products
Rev. 051208 page 119 of 152
Get PVID
Command Name
port get pvid
Description Displays a given port’s VLAN-ID.
Syntax port get pvid <port-no>
Parameters
port-no
port number (1 ~ 14)
Examples
N-TRON/Admin#[1]> port get pvid 6
PVID of port 6 is 4.
NOTES Check whether port-no is in the valid range. (1 ~ 14)
Clear Counters
Command Name
port clear counters
Description Clears all the numbers in the counters for a given port. These are counters
for RX bytes and TX bytes and so on.
Syntax port clear counters <port-no>
Parameters
port-no
port number (1 ~ 14)
Examples
N-TRON/Admin#[1]> port clear counters 6
Counters of Port[6] are : [cleared]
NOTES This will clear all data in the port specific counters. This data cannot be
recovered after this step.
Clear Intruder Log
Command Name
port clear intruderlog
Description This command will clear all intruders out of the intruder log.
Syntax
port clear intruderlog
Parameters None
Examples
N-TRON/Admin#[1]> port clear intruderlog
NOTES This will clear all data from the intruder log. This data can not be
recovered after this step.