Filter
Top Products
Rev. 051208 page 27 of 152
Administration – Gigabit Ports
The ‘Gigabits Ports’ tab under the administration category allows users to change the configuration of the
gigabit ports. The switch may not operate correctly if the slots are not configured properly. You must click
“Update” if you wish to keep the changes.
Notes:
1. In order to verify the settings have been configured and saved correctly, you may want to view the
Logical View page in the found in the web browser interface. The dynamic illustration displayed
on the Logical View page must match the physical switch configuration respectively in order for the
switch to function correctly. If not, please repeat the steps listed above.
2. Validation of the configuration and each physical cable segment may be obtained by using
N-ViewOPC Server software. The software is freely distributed on the ProductCD and our web site
( http://n-tron.com/nview.zip ). Once N-ViewOPC is installed, you should view the Ports Counter
page view each connected port. You may find it helpful to copy [Alt]+[PrintScreen] the Port
Counter information for each port and paste [Control]+[V] into a Windows document for further
review. Please consult your N-View OPC Server Manual for additional information.
Following the Update button, the user may be prompted to Save and Restart the switch in order for changes
to take effect. The switch will save the running configuration into the NVRAM and then cycle power
automatically. Once the switch comes back online the settings will be updated.