Filter
Top Products
p.14
Using the ATTO RAID Controller
G SPEED
eS
PRO
™
Download ATTO RAID Software
To use the ATTO R680 RAID controller, you rst need to install drivers and software on
your system. Visit www.g-technology.com/support/gspeed_es_pro/
Here you will nd a special link to the ATTO website where you can download G-
Technology approved drivers and software. You will also nd the latest verison of this
manual and easy conguration scripts for quickly setting up your G-SPEED eS Pro with
the ATTO controller.
From the G-Technology page* on the ATTO website,
please download the following items:
• Driver for your system
• CongTool utility
• ATTO R680 User Guide (optional)
* The software listed on the ATTO/G-Technology page has been tested
and approved for use with G-SPEED eS Pro. Software listed on the
standard download page on the ATTO website may not be compat-
ible with G-SPEED eS Pro.
Install ATTO Driver & CongTool
G-SPEED eS Pro comes pre-congured for use with the ATTO R680 RAID controller.
The drive is set up in RAID 0 and formatted for Mac OS X. Connecting G-SPEED eS Pro
to your Mac Pro and conguring your system takes just a few steps as outlined below.
(Windows users, please refer to the ATTO R680 User Guide.)
1. Locate the driver and CongTool downloaded from
the ATTO/G-Technology page and install the driver,
then CongTool.
2. The ATTO CongTool can notify you if problems oc-
cur with the G-SPEED eS Pro. If you would like to use
this feature, select ‘Full Installation’.
3. Shut down your system.
download