Filter
Top Products
p.35
Maintenance for Your Drive
G SPEED
eS
PRO
™
WARNING: Make absolutely sure that you remove the correct drive as indicated in the
steps below.
REMOVING THE WRONG DRIVE CAN RESULT IN THE LOSS OF THE ARRAY AND ALL
OF THE CONTENT STORED ON GSPEED ES PRO.
5. The failed drive’s LED will begin to blink in the
G-SPEED eS Pro enclosure, making it easy to
identify which drive needs to be replaced. Be
certain to remove the correct drive, as removing
the wrong drive could cause data loss.
NOTE: It is possible the failed drive will be completely
oine. In this case, the drive’s Activity LED will be com-
pletely turned o, indicating the failed drive.
6. Remove the failed drive by inserting the provided key into the Lock hole and
sliding the drive out of the enclosure.
7. Replace the failed drive with a new disk module and secure in place. Once the drive
has spun up to speed, the CongTool will indicate that the array is rebuilding. The
rebuild time is approximately 1 hour per TB.
Once the rebuild is complete, G-SPEED eS Pro is back to normal, protecting your valu-
able data once again.
NOTE: Replacement and/or extra G-SPEED eS Pro disk modules are available for pur-
chase online at: www.g-technology.com/Products/g-speed-es-pro.cfm
Drive Activity LED