Filter
Top Products
4–16 Configuring the SCANTEAM 3700
4.6 Default Operating Parameters
The SCANTEAM 3700 is configured at the Hand Held Products factory with standard
(default) operating parameters. The default configuration can be used as is or changed
(reconfigured) by downloading new parameters over an RS–232 communications line
from a host instrument. The default configuration settings are listed below.
Default Configuration Settings
• ACK / NAK Disabled
• Baud Rate 9600
• Beeper Mode Disable beeper
• Data Bits 7
• No Read Message “NR”
• Parity Even
• Postamble CR LF
• Preamble Port ID Code ID
• Read Timeout Timeout ends a read attempt, 1.5 seconds
• RTS/CTS Disabled
• Stop Bit 1
• Trigger Mode Serial Trigger or External Trigger, Read Once
• Votes Voting set to 3 for port 1 and set to 1 for port 2
• XON/XOFF Disabled
Default Configuration: Symbology Settings
• Codabar Enabled
Send Start/Stop Yes
Minimum Length 6
Maximum Length 60
• Code 39 Enabled
Require Checksum No
Send Checksum No
Minimum Length 1
Maximum Length 48
• Code 128 Enabled
Minimum Length 1
Maximum Length 80
• I 2 of 5 Disabled
Require Checksum No
Send Checksum No
Minimum Length 6
Maximum Length 80
• UPC A/E, EAN 8/13 Enabled